Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Basic simulation of induction heating
Posted Dec 17, 2010, 3:37 a.m. EST Low-Frequency Electromagnetics, Heat Transfer & Phase Change Version 4.0a 1 Reply
Please login with a confirmed email address before reporting spam
Hello everybody,
I'm just starting to work with Comsol and therefore run into quite a bunch of problems. Most of them are rather basic, but have to be overcome anyway.
However, I've made the appended induction heating model and try to solve it in two steps: First I do a stationary simulation, and then I take the results as initial values for a frequency-transient analysis. In the transient step I get the error message "Failed to find consistent initial values. COMSOL assertion problem.".
Maybe someone can have a look at my model and give me some advice? Any help is greatly appreciated.
Best Regards,
Raphael
I'm just starting to work with Comsol and therefore run into quite a bunch of problems. Most of them are rather basic, but have to be overcome anyway.
However, I've made the appended induction heating model and try to solve it in two steps: First I do a stationary simulation, and then I take the results as initial values for a frequency-transient analysis. In the transient step I get the error message "Failed to find consistent initial values. COMSOL assertion problem.".
Maybe someone can have a look at my model and give me some advice? Any help is greatly appreciated.
Best Regards,
Raphael
Attachments:
1 Reply Last Post Dec 18, 2010, 7:37 p.m. EST
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
My problem should be quite simple to solve for somebody with experience with COMSOL..
I would greatly appreciate if somebody could have a look on my model! Thanks.
I would greatly appreciate if somebody could have a look on my model! Thanks.