Menu

Discussion Forum

New Discussion
Filter

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Modeling of Mass,Spring and Damper system

Posted Dec 24, 2010, 3:30 p.m. EST 1 Reply

Hassan Said
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

HI all,

i would like to ask How could i to make modeling of mass,spring and damper system ??

i attached a photo to discribe what i mean

thanks alot


Hassan
1 Reply Last Post Dec 25, 2010, 4:55 a.m. EST
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago Dec 25, 2010, 4:55 a.m. EST
Hi

there are several ways around:
1) the mathematical one: write out the PDEs compare to the COMSOL internal coefficient PDE and adapt the different parameters, define your domain 1D probably draw a line from 0 to 1, and off you go :)

2) replace the spring k by a simple 1D beam/bar compression spring, add the damping and solve as a simple strutural case

--
Good luck
Ivar
Hi there are several ways around: 1) the mathematical one: write out the PDEs compare to the COMSOL internal coefficient PDE and adapt the different parameters, define your domain 1D probably draw a line from 0 to 1, and off you go :) 2) replace the spring k by a simple 1D beam/bar compression spring, add the damping and solve as a simple strutural case -- Good luck Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content