Menu

Discussion Forum

New Discussion
Filter

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

No Convergence

Posted Jun 12, 2019, 5:06 a.m. EDT Version 5.4 0 Replies

Mahsa
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello, I am new to Comsol and I am trying so simulate the follwing:

A piece of hyperalstic material is placed on top of a rigid body. The hyperelastic materials is then deformed under the gravitational force. I have made a simulation and it works sometimes, for parameters which do not cause a large deformation. However, when increasing for example the mass, Comsol canot find a solution anymore; the error is: No convergence, relative step size too small.

Thanks for your help, Mahsa

Attachments:

0 Replies Last Post Jun 12, 2019, 5:06 a.m. EDT
COMSOL Moderator

Hello Mahsa

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content