Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Boundary Condition with Identity Pair
Posted Jun 20, 2019, 5:57 p.m. EDT Equation-Based Modeling Version 5.4 0 Replies
Please login with a confirmed email address before reporting spam
I am working on a problem in the PDE Equation Modeler. In my geometry, I have an identity pair for which I would like to impose a custom boundary condition. Is there a way to do this in Comsol. I have defined one side as src and one as dst. The BCs I would like to use are below:
On the src boundary: 
On the dst boundary: 
where A, B, C, D, E, F are constants.
Is there a way to set this up as a boundary condition? I think I could use a flux/source boundary to set up the left side if the right side were equal to zero, but I haven't been able to figure out how to reference the u values on the other boundaries.
Thank you for any help.
Hello Caleb Traylor
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.