Menu

Discussion Forum

New Discussion
Filter

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Simulate Exciting and Detection coils

Posted May 9, 2020, 2:01 p.m. EDT Low-Frequency Electromagnetics, Studies & Solvers Version 5.4 0 Replies

Siripong Cheanklin
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Dear All,

I have tried to simulate the induced currents between the exciting primary coil and the second detection coil. I use AC/DC frequency domain model for this simulation at 20kHz. The excitation coil is set up as current excitation: 20 mA. The detection coil is set up as voltage excitation: 0 Volt.

However, I cannot get the second coil inductance (mf.LCoil_2) from the simulation result.

I am not sure about the set up of the detection coil. Please advise on how to solve this problem.

Many thanks,

Siripong

0 Replies Last Post May 9, 2020, 2:01 p.m. EDT
COMSOL Moderator

Hello Siripong Cheanklin

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content