Menu

Discussion Forum

New Discussion
Filter

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Co-simulation between simscape (simulink) with comsol

Posted Dec 6, 2023, 10:34 a.m. EST Interfacing, LiveLink for Simulink 0 Replies

Nor Faezah Binti Adan
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi, I just need some advise on the model I built below. Is there anything wrong with the connection? My plan is to see the current flowing through the comsol model and also the resistors branch when I change electrical conductivity of my electrical tree. The comsol model is a needle-plane dieletric 3D model with an electrical tree.

I have no idea how to connect the ammeter to the comsol block to monitor it's current so I just put one across the resistors branch.

I noticed that no changes to the current eventhough I changed the conductivity of my tree in comsol. I used the electrical current study to reflect the conductivity changes.

So can someone advise what correction i should make to my simscape circuit.

Thanks.

Attachments:

0 Replies Last Post Dec 6, 2023, 10:34 a.m. EST
COMSOL Moderator

Hello Nor Faezah Binti Adan

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content