Eigenfrequency Prestressed not working

Please login with a confirmed email address before reporting spam

Hello I'm doing an Eigenfrequency Prestressed study of a rod and it is giving me this error

**Failed to find a solution. The relative residual (1.9) is greater than the relative tolerance. There was a warning message from the linear solver. Iterative refinement triggered. Returned solution is not converged. Not all parameter steps returned. **

here are the boundary condition that is given 1. The rod has a rigid connector boundary that constrained rotation in x y and z direction place at the bottom of the rod 2. the rod has an added mass boundary of 50 kg at the bottom of the rod 3. gravity is used, set at -9.82 m/s^2 in y direction 4. the material used is anisotropic silicon

The mesh is set at extra fine

attached is the rod mph.file that is used.



1 Reply Last Post Aug 22, 2024, 5:32 a.m. EDT
Henrik Sönnerlind COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 2 months ago Aug 22, 2024, 5:32 a.m. EDT

The stationary load case cannot converge, since the model is underconstrained. All six rigid body motions must be suppressed.

-------------------
Henrik Sönnerlind
COMSOL
The stationary load case cannot converge, since the model is underconstrained. All six rigid body motions must be suppressed.

Reply

Please read the discussion forum rules before posting.

Please log in to post a reply.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.