Adding a mass on a hollow tapered cylinder

Please login with a confirmed email address before reporting spam

Hi, i m trying to add a mass to the top of a tapered hollow cylinder in beams but it's not working. i have tried add point mass but it's not working or it adds the mass at the edge but i need the entire top surface of the cylinder at the center of the top cylinder. Also the top surface should not squeeze in any direction because it only represents in the mass of nacelle-rotor component in a wind turbine model. should i use in this case rigid connector?

thanks Filippo


2 Replies Last Post Aug 22, 2024, 11:40 a.m. EDT
Henrik Sönnerlind COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 2 months ago Aug 22, 2024, 8:21 a.m. EDT

I think you need to attach a sketch or a model file to make it easier for anyone to give suggestions.

-------------------
Henrik Sönnerlind
COMSOL
I think you need to attach a sketch or a model file to make it easier for anyone to give suggestions.

Please login with a confirmed email address before reporting spam

Posted: 2 months ago Aug 22, 2024, 11:40 a.m. EDT
Updated: 2 months ago Aug 28, 2024, 10:30 a.m. EDT

Sorry, I thought I attached it .

Sorry, I thought I attached it .

Reply

Please read the discussion forum rules before posting.

Please log in to post a reply.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.