Menu

Discussion Forum

New Discussion
Filter

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Magnetic flux density (streamlines) and current density by cylindrical condutors

Posted Apr 2, 2014, 2:56 p.m. EDT Low-Frequency Electromagnetics Version 4.4 2 Replies

Akim Borbuev
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello,

I am trying to plot magnetic flux density (streamlines) and current density produced by cylindrical conductors shown in the attached file, for dc and ac (e.g. 50 Hz) cases. But there is a problem occurs when I click on 'compute' and comsol becomes irresponsive,
I would very happy if someone will help me in this matter.

Regards,
Akim

Attachments:

2 Replies Last Post Apr 7, 2015, 6:32 a.m. EDT
COMSOL Moderator

Hello Akim Borbuev

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Anup Anurag
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 10 years ago Apr 7, 2015, 6:22 a.m. EDT
I think you should first define a boundary. Also, use the "Magnetic Field" study and not the "Magnetic Field Formulation" .

Use a Single Turn coil and I hope it will work after that. If you have a 3d geometry where the conductors follow a coil like path, use 2-d axisymetric :)

I hope this helps.

Regards,
Anup
I think you should first define a boundary. Also, use the "Magnetic Field" study and not the "Magnetic Field Formulation" . Use a Single Turn coil and I hope it will work after that. If you have a 3d geometry where the conductors follow a coil like path, use 2-d axisymetric :) I hope this helps. Regards, Anup
Anup Anurag
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 10 years ago Apr 7, 2015, 6:32 a.m. EDT
You can check this out. :)
You can check this out. :)

Attachments:

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content