Menu

Discussion Forum

New Discussion
Filter

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Piezoresistive Pressure Sensor

Posted Mar 8, 2015, 12:37 p.m. EDT MEMS & Nanotechnology, MEMS & Piezoelectric Devices Version 4.4 2 Replies

Tamim Al Mahruz
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Can anyone help me out about the temperature analysis of Piezoresistive Pressure Sensor?
I used thermal expansion in the linear elastic material > sweep the operation temperature.
But output voltage barely change with the differential pressure input.
I know the concept which said it should be higher & lower than 52mV (this is default for this model) during the sweeping.
So how can i find the desired one??
Any help will be appreciated.....
2 Replies Last Post Mar 13, 2015, 1:33 a.m. EDT
Rogelio Hernandez Aguirre
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 10 years ago Mar 12, 2015, 2:46 p.m. EDT
Hi Tamim,

Have you figured how to do it? I am modeling my piezoresistive pressure sensor too, and I am looking to apply temperature and see the change on the output but I do not know how.

Regards

Rogelio
Hi Tamim, Have you figured how to do it? I am modeling my piezoresistive pressure sensor too, and I am looking to apply temperature and see the change on the output but I do not know how. Regards Rogelio
Tamim Al Mahruz
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 10 years ago Mar 13, 2015, 1:33 a.m. EDT
Still finding a way out.
I have already told the procedure that i used but the output varies very narrowly.
In the mean time, can you tell me if i can create a new piezoresistive model using geometry??
Still finding a way out. I have already told the procedure that i used but the output varies very narrowly. In the mean time, can you tell me if i can create a new piezoresistive model using geometry??

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content