Menu

Discussion Forum

New Discussion
Filter

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Changing a curve to surface

Posted Apr 20, 2015, 5:48 p.m. EDT Version 5.0 1 Reply

Olufemi Kadri
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi all,

I have a design which I created in AutoCAD and imported to comsol.The design is a combination of curves which I intend converting to a 2D surface.Can someone please help

I have attached a sample of my comsol file.


Thanks.

Attachments:

1 Reply Last Post Apr 29, 2015, 10:59 a.m. EDT
Frank van Gool COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 10 years ago Apr 29, 2015, 10:59 a.m. EDT
Dear Olufemi,

check that there are no holes in your lines (near 20;23.4 you have a small hole).
After fixing that you can "convert to solid", and then delete the internals of your block.

If you removed the hole in autocad, and alternative would be to set the import to "form solids".

Best regards,
Frank
Dear Olufemi, check that there are no holes in your lines (near 20;23.4 you have a small hole). After fixing that you can "convert to solid", and then delete the internals of your block. If you removed the hole in autocad, and alternative would be to set the import to "form solids". Best regards, Frank

Attachments:

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content