Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Meshing geometary
Posted Apr 22, 2015, 8:44 a.m. EDT Mesh Version 5.0 1 Reply
Please login with a confirmed email address before reporting spam
Hi All,
I am currently using comsol 5.0.
most of the geometry that I am modelling are pretty simple. either cylinders or cubes or cuboids. the ratio of length to thickness is pretty high. lengths being in cm while thickness being as low as 800 nm.
I am finding it very difficult to understand the meshing process. for the squares, i used a specific meshing, but when i try to replicate it in other geometry, it shows me some error. any suggestions of how to understand meshing better?
I am currently using comsol 5.0.
most of the geometry that I am modelling are pretty simple. either cylinders or cubes or cuboids. the ratio of length to thickness is pretty high. lengths being in cm while thickness being as low as 800 nm.
I am finding it very difficult to understand the meshing process. for the squares, i used a specific meshing, but when i try to replicate it in other geometry, it shows me some error. any suggestions of how to understand meshing better?
1 Reply Last Post Apr 23, 2015, 2:04 a.m. EDT
Please login with a confirmed email address before reporting spam
Posted:
10 years ago
Hi
Give an example of unsuccessful meshing problem.
Lasse
Give an example of unsuccessful meshing problem.
Lasse