Solid Mechanics - Failed to find a solution.

Severin Willingsdorfer

Please login with a confirmed email address before reporting spam

Hi,

I am trying to simulate how a catheter deforms, when pushing against a vein. It's a fairly complex catheter (as it is imported from CAD) but a "easy" vein ostium.

I set the boundary load at the end of the shaft with 0.2N and the Fixed contraint on the outside of the vein ostium.

The outter cylinder as well as the cylinder and the cone around the catheter are not used in the solid mechanics module but for another stage later.

I already tried to use Symmetry as the catheter is symmetrical for 1/5 of the circle (see 2.png).

Is there a better way to get this result? Could it be a problem, that the catheter and the ostium aren't in contact yet?



0 Replies Last Post Jun 12, 2024, 6:49 a.m. EDT
COMSOL Moderator

Hello Severin Willingsdorfer

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Reply

Please read the discussion forum rules before posting.

Please log in to post a reply.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.